A Cat – first 3D print on 12-25-18

So when I unpacked (ripped open) my gift on Christmas, I had to set it up. Basically just remove some tape, insert the filament (they provided a small amount of white), insert the small SD card into the printer and select the “Cat” file for my first test print. Well, here you go. As you can see from the above, this prints, layer by layer so it took about 3.5hrs to get this…

And it’s not that quiet – there is movement of gears and such but I’ll spare you folks that for now…

I’m post more later. 

Gilberto 

Leave a Reply

Your email address will not be published. Required fields are marked *