Remember the issue I was having with my Sony HDMI port? The connection on the camera was getting loose from years of use and in order to save some money (and time) to repair the port – I 3D printed a clamp. But I did notice that in day […]
Category: 3D
Upgraded my Ender 3 Pro’s circuit board 9-5-20
Replaced the 16bit circuit board to a new 32bit board on my Ender 3 Pro 3D printer. Nothing wrong with the current board but upgrading (small cost) included these benefits: Quieter stepper motors (not as much noise when printing) Enable thermal runaway (printer shuts down if the heating sensor malfunctions […]
Sony Periscope 3D build 5-23-20
Lego Superman flies 5-8-20
3D Practical Print – Center Finder 5-4-20
G-Man Recon pilot
Raspberry Pi4 mini computer and 3D printed case
Keeping busy and creative with my 3D Printer
3D printing with “The Good Stuff” 3-14-20
Finally getting around to printing with this new Gold filament. Man I love this stuff! Experimenting 3D printing in “VASE mode” whic, which means after the base is printed, the nozzle traces a single continuous path (spiral) until it finishes the model. “Very mesmerizing – see the short movie below” But […]








